Several Common Wiring Problems Of Wire Stripper
Apr 18, 2022
1. Poor fixation: in fact, the insulator of the wire stripper not only plays the role of insulation, but also provides very accurate neutralization protection for the contactor, and has the functions of installation and positioning and fixing on the locking device. The poor fixation of the wire stripper can reliably affect the instantaneous power failure caused by the contact. The main reasons are: unreliable design, improper selection of materials, improper selection of forming process, etc, This leads to lax installation of wire stripper products.
2. Poor insulation: due to some metal surplus on the surface and inside of the insulator of the full-automatic wiring machine of the wire stripping machine manufacturer, due to the pollution of surface dust and flux, organic precipitates and harmful gas adsorption film are fused with the surface water film to form the same channel of ionic conductivity, moisture absorption, mildew, aging of insulating materials and other factors, which will cause short circuit. Low insulation resistance For bad phenomena such as electric leakage and insulation breakdown, the main function of thermal insulation material is to keep the contact in its correct position and connect it with the contact, and the connection between the contact part between the contact part of wire stripper and shell and the contact surface between shell. Therefore, it must have good electrical performance, especially in high density. Due to the wide use of small-size terminals, the effective wall thickness of insulator becomes thinner and thinner, The requirements for die precision and process are also higher and higher.
3. The electronic wire breaking length of the wire stripper is inconsistent: a. the wire feeding wheel may be pressed too tightly or too loose; The principle of adjusting the straightener is that it can straighten and send out smoothly. b. Cutting edge wear or cutting edge; Replace the cutter with a new one.
4. The length of the peeling opening of the computer wire stripper is different: a. the wire feeding wheel is pressed too tightly or loose; Adjust the gap between the two wheels with the fine-tuning part of the wire roller to make the wire not flat, too loose and slippery. b. If the cutter is too shallow or too deep, adjust the cutter head to the appropriate position with the cutter depth adjusting part to avoid damaging the copper wire and degumming smoothly. c. Cutter wear or cutting edge; Replace with a new cutting tool.
