How To Solve The Vibration Of The Metal Shredder

1. The motor rotor of the metal shredder is not concentric with the shredder rotor. You can move the position of the motor to the left or right, or add pads under the motor feet to adjust the concentricity of the two rotors. The rotor of the metal shredder is not concentric. The reason is that the two supporting surfaces supporting the rotor shaft are not in the same plane. Copper can be padded on the bottom surface of the bearing seat, or an adjustable wedge iron can be added to the bottom of the bearing to ensure that the two shaft heads are concentric.

2. If the vibration frequency of the crushing chamber of the metal shredder is relatively high, it may be that the connection between the coupling and the rotor is not concentric or the quality of the flat hammer inside the rotor is uneven. According to different types of couplings, corresponding methods can be adopted to adjust the connection between the coupling and the motor. When the quality of the hammer heads is uneven, each group of hammer heads must be selected again, and the weight difference of each group of hammer heads should not exceed 5g.
3. The vibration of the metal shredder may be because the metal shredder equipment itself has not reached balance. It may be that the metal shredder is not fixed enough. This method is very easy to solve, as long as the metal shredder is not fixed firmly. During the production process, there will be no vibration caused by the insufficient stability of the metal shredder.