How To Replace The Cutter Of The Wire Stripping Machine?

1. Turn off the power: Make sure the wire stripping machine is in a power-off state to prevent accidental startup.
2. Prepare tools: Prepare the corresponding tools as needed, such as wrenches, screwdrivers, etc.
3. Remove the old cutter: Use tools to remove the old cutter from the wire stripping machine. Usually, you need to loosen the screws or nuts that fix the cutter.
4. Clean and inspect: Clean the removed old cutter to remove dirt and debris on the surface. At the same time, check whether the cutter is damaged or severely worn. If so, it needs to be replaced in time.
5. Install the new cutter: Install the new cutter on the wire stripping machine to ensure that the cutter is firmly installed.
6. Adjust the cutter: Adjust the position, angle or depth of the cutter as needed to ensure that the cutter can work properly and achieve the best stripping effect.
7. Check and test: After the installation is completed, check and test to ensure that the cutter is installed correctly and the wire stripping machine can operate normally.
8. Turn on the power: After confirming that everything is normal, turn on the power of the wire stripping machine, perform a trial stripping, and check whether the stripping effect meets the requirements.