How To Effectively Prevent The Blocking Problem Of The Shredder During Operation

First, the speed of feeding should be controlled and not too fast. If the shredder equipment is in production mode, the actual power of the crusher equipment is ignored, and the feeding amount and feeding speed are increased privately in order to increase the output, blocking will occur. Therefore, our staff should always pay attention to the large deflection angle of the ammeter pointer when feeding. If it exceeds the rated current, it indicates that the motor is overloaded. Long-term overload will burn the motor. In this case, the material door should be reduced or closed immediately, or the feeding method can be changed to control the feeding amount by adding a feeder. There are two types of feeders, manual and automatic. Users should choose a suitable feeder according to the actual situation. Because the pulverizer has a high speed, a large load, and a strong load fluctuation. Therefore, the current of the pulverizer when working is generally controlled at about 85% of the rated current.
Secondly, the problem of the discharge pipe. If the discharge pipe is not smooth, the pulverizer air outlet will be blocked. Improper matching with the conveying equipment will cause the discharge pipe to be blocked after the wind is weakened or there is no wind. After finding the fault, you should first clear the delivery port, change the mismatched conveying equipment, adjust the feed rate, and make the equipment operate normally. The cause of the rescue is that the conveyor runs too fast, causing the material discharge speed to be too fast and blocking the discharge pipe.
Long-term crushing of materials with too much moisture causes excessive viscosity on the equipment, causing aging of equipment accessories. The aging of accessories of shredder equipment is mainly concentrated in the broken and aged hammers, and the closed and broken screen holes. Excessive moisture content in the crushed materials will cause the crusher to clog. The high moisture content of the crushed materials by the shredder will accelerate the aging of equipment accessories. Broken and severely aged hammers should be regularly updated to keep the crusher in good working condition, and the screen should be checked regularly. The moisture content of the crushed materials should be less than 14%, which can not only improve production efficiency, but also prevent the crusher from clogging and enhance the reliability of the crusher.